This content University is for students. You are viewing this as a preview; to see content suitable for your group and save your progress, Log inSign up

Chapter 14: Fluid Mechanics

University Physics II: Fluids and Thermodynamics · Chapter 14

14.1 Force, Area, and Pressure

Place the same brick on foam on its three different faces; see that the depression depends on pressure, not force. Rotate a spring-piston pressure sensor in water to show that pressure is independent of direction (scalar), and measure absolute pressure from the spring compression.

Open Simulation

14.2 Pressure with Depth and Hydraulic Lift

Lower the pressure probe into a liquid, plot the P–h graph, and find the density of the unknown liquid from the slope. Measure the same pressure at the same depth in communicating vessels of different shapes (hydrostatic paradox). Lift a car with a small force using a hydraulic lift operating on Pascal's principle.

Open Simulation

14.3 Open-Tube Manometer and Mercury Barometer

Connect gas tanks to an open-end U-tube manometer; calculate gauge and absolute pressure from the level difference in the two arms, and see the difference between mercury and water. Transport a Torricelli barometer to different altitudes and find the height of a mountain from the column height.

Open Simulation

14.4 Dynamometer, Scale, and Archimedes

Slowly submerge an object suspended from a dynamometer into the liquid on a scale; observe that as the dynamometer reading decreases, the scale reading increases by the exact same amount. Find the density of a "crown" from readings in air and water, and measure the density of an unknown liquid from the submerged fraction of a floating wooden cylinder.

Open Simulation

14.5 Continuity Equation: Constricted Pipe

Measure the pump's flow rate from the time it takes to fill a bucket; find the flow velocities in the wide and narrow cross-sections from the transit time of a dye drop between photogates. Test the relation A₁v₁ = A₂v₂, then design a hose nozzle based on the desired exit velocity.

Open Simulation

14.6 Venturi Tube and Torricelli Fountain

Read the pressure drop at the throat from the water levels of three piezometer tubes in a Venturi tube and calculate the flow rate using Bernoulli + continuity; find the condition where the throat pressure drops below atmospheric. Vary the height of a hole in a tank wall to measure the Torricelli speed and maximum range.

Open Simulation

14.7 Wind Tunnel: Airfoil, Atomizer, and Curve Ball

Measure the lift force of an airfoil in a wind tunnel relative to the angle of attack, find the stall angle from the lift coefficient curve, and calculate the model's takeoff speed. Test the required airspeed in an atomizer where airflow sucks liquid up a pipette, and test how a spinning ball curves around a wall via the Magnus force.

Open Simulation